- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 12
Activity overview
Latest activity by anggi_tde-
anggi_tde commented,
- PIX4Dmapper
- How to... (step-by-step instructions)
- How to verify that there is enough overlap between the images
Kapil, thanks for your comments and suggestion. Yes I notice picture distortion when capturing msp camera in the very low altitude.
- View comment
- anggi_tde
- Created
- 0 votes
-
anggi_tde commented,
- PIX4Dmapper
- How to... (step-by-step instructions)
- How to verify that there is enough overlap between the images
Hello, currently I use SQ+ for mapping our agricultural land with 20 cm/px for GSD (around 212 meters above ground). Now I have project to measure very close object (seedling). By calculating GSD n...
- View comment
- anggi_tde
- Created
- 0 votes
-
anggi_tde created a post,
Cannot proccess sequoia multispectral 0.3 MP
Hello Recently I have problem when processing multispectral sensors sequoia+ in P4D. But the problem is only persist when I want to process multispectral with 0.3 MP resolution. For other resolutio...
- anggi_tde
- Created
- 2 followers
- 1 comment
- 0 votes
-
anggi_tde commented,
-
anggi_tde commented,
Hi Fabio, in my experience, I also sometimes found that case in my project and my solution is repeat fly the drone in higher altitude so less detail will be captured in the area. It is better for y...
- View comment
- anggi_tde
- Edited
- 3 votes
-
anggi_tde commented,
Hi There I am Anggi, working as an GIS Officer for oil palm/rubber company in Indonesia. Beside focusing on GIS matter, I also responsible on producing aerial orthophoto in our plantation. I am usi...
- View comment
- anggi_tde
- Created
- 3 votes
-
anggi_tde commented,
Hi Travis, I also had similar problems. But as long the process is not interrupted, it is fine for me although a bit annoying. I also do not have idea why this happen because all the hardware I pur...
- View comment
- anggi_tde
- Created
- 0 votes
-
anggi_tde commented,
Hi very interesting thread. i tried ary sanjaya's project and the result is 579 s (default as in Cloud processing + producing 3D pdf). here is my pc spec PC ASUS ROG G20, P4D ver 3.0.17 CPU - Intel...
- View comment
- anggi_tde
- Created
- 1 vote
-
anggi_tde commented,
Hi I experience the same problem! using win 10 home edition, can only process step 1 but not for step 2 and 3. always crash. WIn 10 home i7 7700 Nvidia 1060 6GB RAM 32 SSD 128 + 512 I already send ...
- View comment
- anggi_tde
- Created
- 0 votes
-
anggi_tde commented,
hi luis, i also have problem by using ebee drone with around 7 cm GSD. it looks like p4d result is a bit blurry rather than photoscan. then p4d support told me to fly higher for achieving at least ...
- View comment
- anggi_tde
- Created
- 0 votes