- Following 0 users
- Followed by 0 users
- Votes 9
- Subscriptions 7
Comments
Recent activity by Daniel Moller Sort by recent activity Recent activity Votes-
Hey, Martin Gryl, did you notice your selection mode is "remove from selection" (at the top bar, beside the button that enables you to edit the cloud). You want to "add points to selection", then c...
- View comment
- Daniel Moller
- Created
- 0 votes
-
- PIX4Dmapper
- How to... (step-by-step instructions)
- How to manually calibrate uncalibrated Cameras in the rayCloud - PIX4Dmapper
Hey, Abdiel. That looks like an elevation, right?The problem with elevations is that they reduce the superposition rate between photos and that is decisive for processing. The superposition setting...
- View comment
- Daniel Moller
- Created
- 0 votes
-
I have two groups of images from different "input" coordinate systems. Can Pix 4D deal with such groups in the same project?
- View comment
- Daniel Moller
- Created
- 0 votes
-
Confirming that annotating (creating a "mask") for water regions in photos improves the results. (Should probably run step 1 alignment again after masking) I had a peer project in which the water ...
- View comment
- Daniel Moller
- Created
- 0 votes
-
Indeed. That step is necessary. Although the system leads us to think the images are already recalibrated. Thank you.
- View comment
- Daniel Moller
- Edited
- 0 votes
-
- PIX4Dmapper
- How to... (step-by-step instructions)
- How to manually calibrate uncalibrated Cameras in the rayCloud - PIX4Dmapper
The issue is too much water in the photos with relatively tiny fixed structures. The system marks most of its automatic tiepoints on the water. After struggling for a while, I managed to have a rea...
- View comment
- Daniel Moller
- Edited
- 0 votes
-
Well, this is a suggestion for a new feature that would certainly help us (and probably many other users). We face this kind of mismatch quite often (long reflective/smooth surfaces/bands). While...
- View comment
- Daniel Moller
- Created
- 0 votes
-
I would like to generate tie points at regular intervals over a polyline, in order to have a good step 1 with good calibration (1), in order to have a better point cloud and a better orthomosaic. T...
- View comment
- Daniel Moller
- Edited
- 0 votes
-
But I'd want this "to generate" a quality orthomosaic in Pix4D, for aligning the cameras properly.
- View comment
- Daniel Moller
- Created
- 0 votes
-
1 - The following cameras (in blue) are badly positioned (ok, they're on the edge, but that's not the issue): 2 - Uncalibrate a few of them to mark tie points (some of the blue became red): 3 - M...
- View comment
- Daniel Moller
- Edited
- 0 votes