- Following 0 users
- Followed by 0 users
- Votes 9
- Subscriptions 7
Activity overview
Latest activity by Daniel Moller-
Daniel Moller commented,
Hey, Martin Gryl, did you notice your selection mode is "remove from selection" (at the top bar, beside the button that enables you to edit the cloud). You want to "add points to selection", then c...
- View comment
- Daniel Moller
- Created
- 0 votes
-
Daniel Moller commented,
- PIX4Dmapper
- How to... (step-by-step instructions)
- How to manually calibrate uncalibrated Cameras in the rayCloud
Hey, Abdiel. That looks like an elevation, right?The problem with elevations is that they reduce the superposition rate between photos and that is decisive for processing. The superposition setting...
- View comment
- Daniel Moller
- Created
- 0 votes
-
Daniel Moller commented,
I have two groups of images from different "input" coordinate systems. Can Pix 4D deal with such groups in the same project?
- View comment
- Daniel Moller
- Created
- 0 votes
-
Daniel Moller commented,
Confirming that annotating (creating a "mask") for water regions in photos improves the results. (Should probably run step 1 alignment again after masking) I had a peer project in which the water ...
- View comment
- Daniel Moller
- Created
- 0 votes
-
Daniel Moller created a post,
Image annotation - Does it apply to realigning the images?
A certain feature that appeared in a group of photos compromised the alignment of our project. Besides using tiepoints to improve the alignment, is it possible to use the annotation tool to remove ...
- Daniel Moller
- Created
- 1 follower
- 0 comments
- 0 votes
-
Daniel Moller commented,
Indeed. That step is necessary. Although the system leads us to think the images are already recalibrated. Thank you.
- View comment
- Daniel Moller
- Edited
- 0 votes
-
Daniel Moller commented,
- PIX4Dmapper
- How to... (step-by-step instructions)
- How to manually calibrate uncalibrated Cameras in the rayCloud
The issue is too much water in the photos with relatively tiny fixed structures. The system marks most of its automatic tiepoints on the water. After struggling for a while, I managed to have a rea...
- View comment
- Daniel Moller
- Edited
- 0 votes
-
Daniel Moller commented,
Well, this is a suggestion for a new feature that would certainly help us (and probably many other users). We face this kind of mismatch quite often (long reflective/smooth surfaces/bands). While...
- View comment
- Daniel Moller
- Created
- 0 votes
-
Daniel Moller commented,
I would like to generate tie points at regular intervals over a polyline, in order to have a good step 1 with good calibration (1), in order to have a better point cloud and a better orthomosaic. T...
- View comment
- Daniel Moller
- Edited
- 0 votes
-
Daniel Moller commented,
But I'd want this "to generate" a quality orthomosaic in Pix4D, for aligning the cameras properly.
- View comment
- Daniel Moller
- Created
- 0 votes