How to process a single step

Follow

This article explains how to process a single step, when creating a new project or for existing projects in PIX4Dmapper.

 
Information: It is possible, and recommended, to process the project one step after the other:
  1. 1. Initial Processing
  2. 2. Point Cloud and Mesh
  3. 3. DSM, Orthomosaic and Index
 
Tip: In particular, it is strongly suggested to run step 1, which performs the calibration of the images and the 3D reconstruction, first and to analyze the results before going further with steps 2 and 3. For more information: Quality Report Help.

New project

To process step 1 only, proceed as follows:

  • When creating a new project:
    • Uncheck the Start Processing Now box at the end of the wizard before clicking Finish.

Project_wizard_processing_options_PIX4Dmapper_v2.jpg

Visualization of the Start Processing Now box on the Processing options templates window.

Existing projects

To process only one step in existing projects, follow these steps:

  • On the menu bar, click View > Processing.
  • In the processing bar, uncheck steps 2 and 3 before clicking Start.

    processing_bar_step1_checked.png
 
Warning: This also applies in case only step 2 or only step 3 has to be processed. Uncheck any steps that should not be re-run as it would erase previous results.
Was this article helpful?
2 out of 2 found this helpful

Article feedback (for troubleshooting, post here instead)

0 comments

Article is closed for comments.